| Technical specifications |
| MODEL SPECIFIC |
| Adjustment Type | Potentiometer |
| Connection Type | Connector, 4-pin M12 |
| Housing Type | Rectangular |
| Optical Block | Type V1G, Glass, Focused Lens "V" Axis
Direct lens “V” axis sensing at close ranges. Used for small part or precise leading edge sensing. |
| LED Light Source | Infrared = 880 nm |
| Sensing Range | 4in |
| FAMILY SPECIFIC |
| Supply Voltage | 12 to 24 VDC
Polarity Protected |
| Current Requirements | 85mA (exclusive of load) |
| Output Transistors | - (1) NPN and (1) PNP sensor output transistor
- NPN Sink up to 150mA
- PNP Source up to 150mA
- Momentary short circuit protected
- Outputs protected from pulsing during power up
- Light/dark switch determines output status
Light = Light "ON" operate
Dark = Dark "ON" operate |
| Response Time | - Minimum duration of input event
- Light state response = 50 microseconds
- Dark state response = 140 microseconds
- Leading edge variation less than 20 microseconds
|
| Hysteresis | Less than 400 millivolts for maximum sensitivity and resolution |
| Indicators | - OUTPUT INDICATOR: Red LED illuminates and the NPN or PNP outputs switch to the opposite state when retunred light level exceed "5" on the CONTRAST INDICATOR
- EDR® INDICATOR - Intensity of GREEN LED provides indication of where in the dynamic operating range the offset, EDR® adjustment has been set
- FULLY LlT: Operating near saturation
- OFF: Operating near maximum sensing range
- CONTRAST INDICATOR Displays scaled reading of sensor's response to contrasting light levels (light vs. dark) on a ten bar LED display
|
| Light Immunity | Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light, including high intensity strobes |
| Ambient Temperature | -40°C to 70°C (-40°F to158°F) |
| Rugged Construction | - Chemical resistant, high-impact polycarbonate housing
- Waterproof, NEMA 4X, 6P and IP67 enclosure ratings
- Epoxy encapsulated for mechanical strength
|
