| TECHNICAL DATA |
| GENERAL DATA |
| Power Supply | 10..40 Vdc; 19..28 Vac |
| Consumption | 1W @ 12 Vdc |
| Isolation | 1.500 Vac |
| LED status indicators | Power Supply / Error / Rx/Tx Data |
| Operating Bandwdth | g3, annexed 1 ERC 70-03 (869.4 MHz – 869.650 MHz) |
| Modulation | DSSS |
| Coverage distance | 1.000 m free field with BER < 10-3 @ 9.6 kbaud (antenna in free space, 2 m height from the grountd) |
| Crypting | AES 128 bit |
| Antenna | ANT Mag (standard) SMA male , ANT-LINK1-MG (option) |
| Connectors | ANT Mag (standard) SMA male , ANT-LINK1-MG (option) RJ10 connector for RS232 serial port Jack stereo connector for programming Antenna connector Rear IDC10 connector for SENECA bus Removable 3-way screw terminals |
| Dimension | 17,5 x 100 x 112 mm |
| Operating Tempeature | 0..55°C |
| Weight | 200 g |
| Case | PA6, black color |
| Protection Degree | IP20 |
| Mounting | 5 mm DIN rail (CEI IEN 60715) |
| Operating Mode | Point-to-point, Point-to-multipoint, I/O repeater, Bridge, Remote I/O |
| Programming | EASY SETUP, DIP-switch |
| COMMUNICATION |
| Interface | N°1 RS232, N° 1 RS485 |
| Protocol | ModBUS RTU |
| Physical Layer | LoRA |
| Data Rate | 1.200…115.200 bps |
| Delay time | >250 ms |
| Timeout | Max value among configured timeout values |
| Nodes | 32 |
| Communication Mode | Half Duplex |
| Power Transmission | 40 mW |
| STANDARD |
| Approvals | CE, ETSI |
| Norms | ETSI EN 300 220-2 V2.1.2 (2007-06) ETSI EN 301 489-3 V1.4.1 (2002-08) CEI EN 61010 Radio and telecommunications terminal equipment directive 99/5/EC Electromagnetic compatibility directive 2004/108/EC Low Voltage equipment directive 2006/95/EC ERC REC 70-03
|