Specifications |
SUPPLY VOLTAGE | 10 to 30 VDC on 4-20mA and 0-5 VDC models 15 to 30 VDC for 0-10 VDC models Polarity Protected |
CURRENT REQUIREMENTS | UVS-1A through 4A; 50 mA max UVS-5A & 6A; 65 mA max (exclusive of load) |
DIGITAL OUTPUT | (1) NPN and (1) PNP output transistor: NPN: Sink up to 150 mA PNP: Source up to 150 mA Continuous short circuit protected Outputs protected from pulsing during power up |
ANALOG OUTPUT | • 4 – 20 mA; 0-5 VDC; or 0-10 VDC |
RESPONSE TIME | 200us for UVS-1A through 4A 750µs for UVS-5A 300µs for UVS-6A |
AMBIENT TEMPERATURE | -15°C to +70°C (5°F to 158°F) |
LIGHT IMMUNITY | Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light, including indirect sunlight |
CONNECTION TYPE | Built in 6" pigtail cable with 5-Pin Male, M12 Mini Micro connector |
PUSHBUTTON CONTROL | AUTOSET pushbutton setup Tweak adjustments with “UP” or “DWN” buttons Selection of Light/Dark operation Enable/Disable pulse stretcher "Select" button scrolls thru four AUTOSET modes |
DIAGNOSTIC INDICATORS | Contrast Indicator – Display scaled reading of sensor’s response to contrasting UV light levels (light vs. dark) on an 8 bar LED display Note: All 8 LEDs will flash three times if contrast insufficient or too low in Two-Point AUTOSET mode Red LED Output Indicator – Illuminates when the sensor’s output transistors are “ON” NOTE: If Output LED flashes, a short circuit condition exists Green LED Timer Indicator – Illuminates when the 15 ms pulse stretcher timer is enabled |
LIGHT SOURCE | UV LED, 375 nm Wavelength |
RUGGED CONSTRUCTION | Chemical resistant high impact polycarbonate housing, acrylic or glass lens cover Industry Ratings: NEMA 4, IP67 |
CERTIFICATIONS | UL, CE, RoHS |