| Specifications |
| Model Specific |
| Adjustment Type | Knob |
| Connection Type | Connector, 4-pin M12 |
| Housing Type | Rectangular |
| Optical Block | Type F1, Fiberoptic Adapter
Adapts sensor to any standard fiber optic light guide with .187" O.D. tips. The light guide is inserted and held in place with a slide-action snap. |
| LED Light Source | White=Broadband Color Spectrum
The “White Light” LED light source promotes easy detection of the largest variety of color marks printed on the largest variety of colored web materials. By combining a white LED light source, our Contrast Indicator, and the one-push AUTOSET setup, you have a winning combination of high performance with an easy to use sensor. |
| Sensing Range | Opposed Mode with F1: 1.75in.
Opposed Mode with F1 with Lens: 6.5ft.
Proximity Mode with F1: 0.5in using a .125in diameter fiber bundle
Proximity Mode with F1 with Lens: 2in using a .125in diameter fiber bundle |
| Family Specific |
| Supply Voltage | 12 to 24 VDC
Polarity Protected |
| Current Requirements | 85mA (exclusive of load) |
| Output Transistors | (1) NPN and (1) PNP sensor output transistor
NPN Sink up to 150mA
PNP Source up to 150mA
Momentary short circuit protected
Outputs protected from pulsing during power up
Light/dark switch de4termines output status
Light=Light "ON" operate
Dark=Dark "ON" operate |
| Response Time | Minimum duration of input event
Light state response=50 microseconds
Dark state response=140 microseconds
Leading edge variation less than 20 microseconds |
| Hysteresis | Less than 400 millivolts for maximum sensitivity and resolution |
| Indicators | - OUTPUT INDICATOR: Red LED illuminates and the NPN or PNP outputs switch to the opposite state when retunred light level exceed "5" on the CONTRAST INDICATOR
- EDR® INDICATOR - Intensity of GREEN LED provides indication of where in the dynamic operating range the offset, EDR® adjustment has been set
- FULLY LlT: Operating near saturation
- OFF: Operating near maximum sensing range
- CONTRAST INDICATOR – Displays scaled reading of sensor's response to contrasting light levels (light vs. dark) on a ten bar LED display
|
| Light Immunity | Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light, including high intensity strobes |
| Ambient Temperature | -40°C to 70°C (-40°F to158°F) |
| Rugged Construction | Chemical resistant, high-impact polycarbonate housing
Waterproof, NEMA 4X, 6P and IP67 enclosure ratings
Epoxy encapsulated for mechanical strength |
