| Specifications |
| Model Specific |
| Adjustment Type | Knob |
| Connection Type | Connector, 4-pin M12 |
| Housing Type | Rectangular |
| Optical Block | Type R1, Retroreflective
Turns the sensor into a retroreflective sensor. |
| LED Light Source | Infrared = 880nm
Recommended in opaque object sensing applications. Infrared LED light source provides long-range sensing in either Beam Make or Beam Break modes. Infrared light maximizes the sensor’s ability to penetrate contamination found in harsh environments. |
| Sensing Range | 35ft |
| Family Specific |
| Supply Voltage | 12 to 24 VDC
Polarity Protected |
| Current Requirements | 85mA (exclusive of load) |
| Output Transistors | (1) NPN and (1) PNP sensor output transistor
NPN Sink up to 150mA
PNP Source up to 150mA
Momentary short circuit protected
Outputs protected from pulsing during power up
Light/dark switch de4termines output status
Light = Light "ON" operate
Dark = Dark "ON" operate |
| Response Time | Minimum duration of input event
Light state response = 50 microseconds
Dark state response = 140 microseconds
Leading edge variation less than 20 microseconds |
| Hysteresis | Less than 400 millivolts for maximum sensitivity and resolution |
| Indicators | OUTPUT INDICATOR: Red LED illuminates and the NPN or PNP outputs switch to the opposite state when retunred light level exceed "5" on the CONTRAST INDICATOR
EDR® INDICATOR - Intensity of GREEN LED provides indication of where in the dynamic operating range the offset, EDR® adjustment has been set
FULLY LlT: Operating near saturation
OFF: Operating near maximum sensing range
CONTRAST INDICATOR – Displays scaled reading of sensor's response to contrasting light levels (light vs. dark) on a ten bar LED display |
| Light Immunity | Responds to sensor’s pulse modulated light source, resulting in high immunity to most ambient light, including high intensity strobes |
| Ambient Temperature | -40°C to 70°C (-40°F to158°F) |
| Rugged Construction | Chemical resistant, high-impact polycarbonate housing
Waterproof, NEMA 4X, 6P and IP67 enclosure ratings
Epoxy encapsulated for mechanical strength |
