| Specifications |
| CAN Interface |
| Controller | Microprocessor inside with 20MHz |
| Transceiver | NXP 82C250 |
| AMIS 41682 | 1 |
| Connector | 9-pin male D-Sub (CAN_L, CAN_H, N/A for others) |
| Baud Rate (bps) | 10 k, 20 k, 50 k, 100 k, 125 k, 250 k, 500 k, 800 k and 1 Mbps |
| Protection | 3000 VDC power protection on CAN side, 2500Vrms photo-couple isolation on CANbus |
| Terminator Resistor | Selectable 120 ? terminator resistor by jumper |
| Support Protocol | CAN 2.0A/2.0B |
| Receive Buffer | 1000 data frames |
| UART Interface |
| COM | RS-232 |
| Connector | 14-pin terminal connector
RS-232 : TxD, RxD, GND
RS-422 : Tx+, Tx-, Rx+, Rx
RS-485: D+, D |
| Baud Rate (bps) | 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps |
| Data bit | 5, 6, 7, 8 |
| Stop bit | 1, 2 |
| Parity | None, Even, Odd |
| Receive Buffer | 900 data frames |
| LED |
| Round LED | ON LED: Power and Data Flow; ERR LED: Error |
| Power |
| Power Requirement | Unregulated +10VDC ~ +30VDC. Power reverse protection, Over-Voltage brown-out protection |
| Power Consumption | 1 W |
| Mechanism |
| Installation | DIN-Rail |
| Dimensions | 72mm x 118mm x 33mm (W x L x H) |
| Environment |
| Operating Temp. | -25 ~ 75° C |
| Storage Temp. | -30 ~ 80° C |
| Humidity | 10 ~ 90% RH, non-condensing |
