Specifications |
Hardware |
J1939 Port Channels | 1 |
CAN Interface |
Controller | Microprocessor inside with 96 MHz |
Transceiver | NXP 82C250 |
Connector | 9-pin D-sub connector |
Baud Rate (bps) | 250k |
Isolation | 3000 VDC power protection on CAN side, 2500Vrms photo-couple isolation on CAN bus |
Terminator Resistor | Selectable 120? terminator resistor by jumper |
Specification | ISO-11898-2, CAN 2.0A and CAN 2.0B |
Pin Assignment | C.I.A. DS-102 (CAN_H=7, CAN_L=2) |
UART Interface |
Connector | 14-pin screw terminal connecter |
COM1 | RS-232(TXD, RXD, GND) / RS-422(Tx+, Tx-, Rx+, Rx-) / RS-485(D+, D-) |
Baud Rate (bps) | 2400, 4800, 9600, 19200, 38400, 57600, 115200 |
LED |
Round LED | PWR / J1939 / MODBUS |
Power |
Power supply | +10 ~ +30 VDC |
Power Consumption | 1.5W |
Dip Switch | Init (Firmware Update) / Normal (Firmware Operation) |
Mechanism |
Installation | DIN-Rail |
Dimensions | 108mm x 72mm x 35mm (H x W x D) |
Environment |
Operating Temp. | -25 ~ 75° C |
Storage Temp. | -30 ~ 80° C |
Humidity | 10 ~ 90% RH, non-condensing |